This article describes if there is any specific LED indications to look for to be sure the module is running after the powering on the CompactCom 30 and CompactCom 40.
APPLICABLE PRODUCTS
CompactCom 30, CompactCom 40
QUESTION
After powering on the CompactCom, are there any specific LED indications to look for to be sure the module is running?
ANSWER
No, there may be exceptions, but the LED:s are normally not enabled until the module initialization is finished. I.e. when the CompactCom passes through NW_INIT state.
The LED indications are network dependent, see each CompactCom network specific guide for more information.