Login
logo

How to perform a Factory reset on the IN***DAL064O500 gateway

25 Jan 2023
This article explains the steps to perform a factory reset of an Intesis DALI Protocol Translator. The Intesis DALI Protocol Translators can be factory reset by powering on the device while holding down the A & B buttons.

 

APPLICABLE PRODUCTS

  • Intesis DALI Protocol Translators: INBACDAL0640500, INMBSDAL0640500

 

PRE-REQUISITES

Physical access to Intesis DALI Protocol Translator.

 

IN THIS ARTICLE

FACTORY RESET PROCESS

  1. Power off the gateway.
  2. Hold both the A & B buttons (1) down while powering the device until both LEDs (2) light up.

mceclip0.png

  1. Release the buttons. Both LEDs (2)  start Blinking alternately until the Turnoff when the Process is finished.